surface mount electrical devices > GreenBuildingTalk - Green Building Forums on Insulating Concrete Forms (ICF), Structural Insulated Panels (SIP), Radiant Heating, Geothermal Heat Pumps, Solar Power

Forums

Members

You are not authorized to post a reply.

Author

Messages

richkel

Registered Users

Posts:1

08/26/2008 8:56 PM
Hi Folks, Another newby here so forgive me if this has been discussed; I've been reading about energy efficient building and with all the attention placed on maximizing insulation and maintaining a near perfect air/vapor barier, it seems like all those electric boxes and wires degrade the exterior wall system. I'd want to put all that on the surface using wiremold type devices. (Yes I know that would be asthetically un-appealing to some). Do people do that? Is it OK by most codes for new construction? thanks for all the good reading on this site Rich

gregj

Registered Users

Posts:168

08/28/2008 12:13 PM
It can meet code in most places but I've never seen it intentionally done on new residential construction. There are good ways to seal off boxes and wiring holes within the walls. You might also be able to put electrical outlets in the floor.

cmkavala

Registered Users

Posts:818

08/28/2008 3:46 PM
You can suface mount bell boxes

Chris Kavala chris@southernsips.com 1-877-321-SIPS

James Eggert User is Offline

Registered Users

Posts:1001

08/28/2008 7:51 PM
It can be done and is allowed, however, the house would appear to have had electrical added as an after-thought! The minimal insulation that is affected is just that....minimal!

Take Care Jim Design/Build/Consulting "Not So Big" Design Proponent

You are not authorized to post a reply.

Professionals Serving
Your Location: