Status Light > GreenBuildingTalk - Green Building Forums on Insulating Concrete Forms (ICF), Structural Insulated Panels (SIP), Radiant Heating, Geothermal Heat Pumps, Solar Power

Forums

Members

You are not authorized to post a reply.

Author

Messages

davar

Registered Users

New Member

Posts:5

06/14/2008 9:44 PM
Hello. When I went to start my waterfurnace premier for the first time in a month, nothing happened and the status light is blinking.I shut off the breaker and turned it on again and it does the same.Anyone got an idea of the problem? I will call the service center Monday but just wondered whats wrong.Thanks

engineer

Registered Users

Advanced Member

Posts:584

06/14/2008 10:51 PM
Satus light blinking is normal for my Envision. Envision is closely related to Premier. My guess is your unit is not getting "calls" from thermostat or zone controller

Without data, you only have an opinion.

fsq4cw

Registered Users

New Member

Posts:21

06/15/2008 1:27 AM
Before you call for service, do the logical things, like check or replace your air filter, vacuum the air heat exchanger & clean your condensate drain. SR

engineer

Registered Users

Advanced Member

Posts:584

06/15/2008 9:32 AM
Those suggestions are all good but none of them will cause a unit not running to run

Without data, you only have an opinion.

TRI-L

Registered Users

New Member

Posts:6

06/16/2008 1:45 PM
IF you have Internet access LOL. Go to Waterfurnace.com and down load owners manual, go to page 35.

You are not authorized to post a reply.